Position sizing: the 1% rule explained

Kévin KOUSSOUGBE
· 3 min read

Most trading accounts don't blow up because of a bad strategy but because of bad risk management: one oversized position at the wrong moment is enough to wipe out weeks of gains. The good news is that position size is the only variable you fully control on a trade. Here's how to calculate it properly.

The principle: start from risk, not lot size

The classic mistake is to pick a volume first ("I'll take 1 lot") and then place your stop-loss wherever it "doesn't hurt too much". Do it the other way round:

  1. Decide the maximum amount you're willing to lose on the trade (as a % of capital).
  2. Place the stop-loss where your analysis is proven wrong, not where it suits you.
  3. Work out the position size that makes the two match.

The market dictates the stop-loss, your plan dictates the risk. Position size is simply the result of both.

The formula

Position size = amount at risk ÷ (stop distance × value of one point per lot)

In forex, for a dollar-quoted pair like EUR/USD and a USD account, one pip is worth $10 per standard lot (100,000 units).

Worked example

  • Capital: $10,000
  • Risk per trade: 1%, i.e. $100
  • Stop-loss: 25 pips
  • Pip value: $10 per standard lot

Position size = 100 ÷ (25 × 10) = 0.4 lots.

If the next setup calls for a 50-pip stop, the size becomes 100 ÷ (50 × 10) = 0.2 lots. The dollar risk stays the same, and that's the whole point. A wider stop doesn't mean more risk; it means a smaller position.

Why 1% and not 5%

The percentage looks harmless until you look at a losing streak. And ten losses in a row happen to any strategy, even a profitable one, over a long enough sample.

  • At 1% per trade, ten straight losses leave the account at about -9.6%. You then need +10.6% to break even.
  • At 5% per trade, the same ten losses drop the account by about -40%. You then need +67% to get back to where you started.

Losses are asymmetric: the deeper the hole, the longer the climb out (we go into this in the article on maximum drawdown). 1% isn't a magic rule (some experienced traders go up to 2%, others down to 0.5%), but it keeps the account in a zone where a bad run stays an accident rather than the end of the road.

Traps that throw off the calculation

Spread and commissions. On a tight stop, the spread is a big part of your real risk. A 10-pip stop with a 1.5-pip spread is in practice 15% more risk.

Pairs not quoted in dollars. On USD/JPY or EUR/GBP, the pip value depends on the exchange rate and changes over time. Use the value your platform shows rather than a fixed number.

Several correlated positions. Three 1% trades on EUR/USD, GBP/USD and AUD/USD, all long, aren't three independent risks. They're closer to a single 3% bet against the dollar.

Rounding to the minimum lot. If the calculation gives 0.37 lots, use 0.37 if your broker allows it, otherwise round down, never up.

Check that you actually follow your rule

Having a 1% rule and following it are two different things. The only way to know whether your risk management holds up over time is to look at your real history: is your average loss steady from one trade to the next, or are some losses three or four times bigger than the rest? Those gaps almost always point to position sizes decided on emotion, which is exactly what an analysis of your MT4/MT5 history brings to light.